Milk

This post is also available on: German

Note: Since the rules for the implementation of the MLP may differ in the federal states and the EU, the configuration of the MLP in the settings should only be done by an authorized person. To do this, contact your dealer or the control association or association responsible for your business.

1. Set up under Organization > Settings > Constants > Milch

A default configuration is set up under settings > Constants (Default) > Milk > Germany . This is active if under Settings > Farm data > Milk has been set to use at default settings.

MRec.. Days valid:| determines the period during which another MRec must have been made in order for the animal to be calculated, standard 60

Colostrum… Days after calving | determines the duration of the colostrum period, after the end of the period the animal is presented to the MRec, the duration is determined by national determinations

Type of MRec | determines the allocation of boxes and bottles to the stock to be tested

Testing method | determines how and by whom the MRec must be conducted in operation

Milking Frequency | sets the number of milking times per day for a stock or parts thereof

Test interval | determines the number of tests to be performed per unit of time

MRec Check Scheme | regulates how and from which milk samples the milk samples are to be taken, a distinction is made between alternating/non-alternating

2. Set up in Organization > Settings Operating > data Operation > > Milk

  1. Open settings > Farm data > farm > Milk
  2. Remove to configure use for default settings
    • if the tab operation is selected, all selected settings apply to all BU’s of the farm
  1. Set the validity of the MRec
  2. determine the duration of the colostral period
  1. click on General
    • General conditions for the MRec are set under this tab.
      • Validity of the MRec
      • Duration of the colostrum phase
  2. Click on Germany and determine how the MRec should be carried out in the entire operation

3. Set up in Organization > Settings > Farm data > BU > Milk

Note: where different BU are managed in a dairy holding and the provisions of the BU differ from those of the whole holding, different arrangements may be set for the Sector concerned. To do this, the use with default settings must be removed (see also 2.)

  1. Open settings > farm data > 01 – AE/Stall 1
  2. Enter the deviating information for the respective BU as under 2nd tab farm
  1. Finish typing with Save