Suspicion of structural deficiency (31-100 days)
This post is also available on:
1-30 days
31-100 days
101-200 days
>=> 201 days
Unobtrusive
Unobtrusive
Unobtrusive
Unobtrusive
Definition/Causes
Decreasing fat content may indicate decreasing structure content in the ration. It is primarily caused by an excess of easily soluble carbohydrates.
Rumination activity and saliva production are restricted. As a result, insufficient buffering of the volatile fatty acids and a drop in the pH value in the rumen. There is a risk of latent acidotic exposure. Due to reduced acetate fermentation and increased propionate fermentation, the milk fat content decreases.
An excess of energy increases the protein content.
Causes
- Feed ration is structurally poor and/or contains inferior coarse feed
- Non-rumen-friendly use of concentrated feed (too high proportion of easily soluble carbohydrates – caution: risk of acidosis)
Milk fat drops are to be distinguished by:
- Heat stress, high humidity, mastitis and insufficient energy supply (poor feed quality)
- Performance
- Recovery after excessive body mass loss due to ketosis
- severe emaciation.
Signal values: Decrease in F% >= 0.4% compared to previous month
red
>= 45 % in the lactation section
orange
>= 18% in the lactation section + structural deficiency
>= 20% in lactation section 101. up to 200th day
>= 10 % in the lactation section > 200 days
yellow
>= 18 to < 45% in the lactation section
Measures
Goal: Increasing forage intake with the best feed quality
Check feed intake
- Avoid unrestricted access to the feeding area Avoid overcrowding (animal: feeding area = 1:1)
- Check the frequency of forage submission (3 x)
- Securing the water supply
- Check the amount of residual feed (at least 5%)
- is the feed ration (calculated) also eaten?
Check feed quality
- Energy content preferably above 6.5 NEL/kg DM in roughage
- Secure 400 g of crude fibre for every 100 kg of body mass. Pay attention to the proportion of structurally effective crude fiber. 8 – 10% of the particles should be larger than 4 cm.
- Feed without impurities and deteriorations (dirty, moldy, frozen)
- The basic feed:concentrate ratio should not exceed 40:60.
Check feed ration
- Ration calculation and ration control
- Securing the structure
- Correct assignment to feeding groups
Other measures
- Observe a change in the consistency of feces (transition to light-colored, thin-tangled feces)